How to change the battery in a 2GIG Keyfob

If the batteries in your keyfob are low, follow the steps outlined below to replace them.

1. Use a small screwdriver to remove the screw on the back of the keyfob.
   
2. Use a small flatblade screwdriver, key, or coin to use the pry notch to pry the keyfob open.
   
3. Remove the dead battery from the battery tray and dispose of it properly.
   
4. Insert the new CR2025 battery paying close attention to the orientation of the battery, when you replace the battery the positive side of the battery will be facing upward.
5. Once the battery is installed in the keyfob, snap the back cover in place, then reinsert the screw that holds it together.
6. With the keyfob back together, test the fob for function by using it to arm, and disarm the alarm system.

How to test a 2GIG Keyfob

To test the keyfob for proper function, follow the steps outlined below.

1. Press and hold the Arm Away button for 3 seconds, ensure the light on the keyfob lights up, and ensure that the alarm panel arms in Away mode.
   
2. Press and hold the Disarm button for 3 seconds ensure the light on the keyfob lights up, and ensure that the alarm panel Disarms.
   
3. Press and hold the Arm Stay button for 3 seconds ensure the light on the keyfob lights up, and ensure that the alarm panel arms in stay mode.
   

You can also test the panic button on the keyfob. In order to do this, it is best to contact our Technical Support department so that we can place the account on test and verify that a signal is sent to the monitoring station.

Contact Us